guglspots.blogg.se

1. #USING SEPEREATE MIXES IN SAFFIRE MIXCONTROL WITH PT11 HOW TO#
2. #USING SEPEREATE MIXES IN SAFFIRE MIXCONTROL WITH PT11 PRO#

Zero Latency Tracking – Routes Mix 1 and Mix 2 (or Mix 1 (L) and Mix 1 (R)) to each pair of analogue outputs.DAW Tracking – Routes DAW 1 and DAW 2 (outputs 1 and 2 from your computer) to each pair of analogue outputs.More information about these can be found in Part I of this tutorial.Ĭlicking on the Routing Preset… button to the left of your monitor outputs in the routing pane gives access to the following five preset routing configurations that can be used as an alternative to configuring the routing manually: Mixes are the audio streams created by a combination of Inputs and DAWs.DAW contains all of the audio streams coming back from your computer, whether from your recording software, or from a media player, or System Sounds.This will route audio straight from the selected audio input, to the selected audio output, without incurring the latency of a round trip down the FireWire bus and back. Inputs are the audio inputs on your interface, both analogue and digital.As shown below, you will be able to choose between 3 different types of audio streams: Inputs, DAW, and Mixes. To assign an output, click on the button next to that output.

#USING SEPEREATE MIXES IN SAFFIRE MIXCONTROL WITH PT11 HOW TO#

The first section of this MixControl tutorial is going to focus on the top half of the control panel (shown below), and how to use it to create custom mixes that can be routed to any of the outputs on your interface. This panel shows all of the available outputs on your interface (the screenshot above shows Saffire MixControl with a Liquid Saffire 56 connected), and each output has a button next to it that can be used to assign a specific audio stream to that output. This guide applies to the Current Saffire Range and is also relevant to the 1st Generation Scarlett 6i6, 8i6, 18i6, 18i8 and 18i20.

#USING SEPEREATE MIXES IN SAFFIRE MIXCONTROL WITH PT11 PRO#

Please Note: If you are using a Saffire PRO 24 DSP or a Liquid Saffire 56 and can only see the first 2 outputs, click on the button to the left of the one marked Routing Preset…, and select Router. This panel can be found in the bottom left-hand corner of Saffire MixControl. This is done predominantly using the routing panel, shown below. When you have created your mixes (see Part I of this tutorial), you then need to route them to the outputs of your device. Applies to: Saffire Range and 1st Generation Scarlett 6i6, 8i6, 18i6, 18i8 and 18i20